ดร.ปรีชา ขันติโกมล
Dr.Preecha Khantikomol

ห้องปฎิบัติการวิจัยและพัฒนาพลังงานทดแทน
(Research and Development of Renewable Engergy Laboratory (RDREL)


ตำแหน่ง
ผู้ช่วยคณบดีฝ่ายวิชาการและวิจัย คณะวิศวกรรมศาสตร์และสถาปัตยกรรมศาสตร์

หน่วยงาน สาขาวิชาวิศวกรรมเครื่องกล คณะวิศวกรรมศาสตร์และสถาปัตยกรรมศาสตร์
               (Department of Mechanical Engineering, Faculty of Engineering and Architecture)
E-Mail Address : preecha@rmuti.ac.th

 
ประวัติการศึกษา
ปีที่จบ ระดับการศึกษา วุฒิการศึกษา สาขาวิชา Major ชื่อสถาบัน ประเทศ
2553
(2010)
ปริญญาเอก D.Eng Energy and Environmental Engineering Mechanical and Energy Engineering Oita University Japan
2548
(2005)
ปริญญาโท วศ.ม วิศวกรรมเครื่องกล Mechanical Engineering มหาวิทยาลัยเทคโนโลยี
พระจอมเกล้าธนบุรี
ไทย
2541
(1998)
ปริญญาตรี วศ.บ. วิศวกรรมเครื่องกล Mechanical Engineering มหาวิทยาลัยเทคโนโลยี
พระจอมเกล้าธนบุรี
ไทย
 
สาขาวิชาที่ทำวิจัย
  - Fluid Flow in Porous Medial
  - Energy
  - Heat and Mass Transfer in Porous Media
  - Shock Wave
  - Thermodynamics analysis
 
ประสบการณ์งานวิจัย
งานวิจัยที่กำลังทำ
- Analysis of the optimization of flow insulation system by using metal foam
- Study of Single Layer Flow Insulation System by Using Stainless Steel Cross Mesh
- Study of Multilayer Flow Insulation System by Using Stainless Steel Mesh
- Pyrolysis of Residual Biomass
- Improvement of the Small Engine Using the Producer Gas
- Biomass gasification of the residual agricultural biomass for agricultural engines
- Study of radiation characteristics of stainless steel cross mesh
 
 
งานวิจัยที่ได้ตีพิมพ์เผยแพร่

วารสารระดับนานาชาติ

Preecha Khantikomol and Kouichi Kamiuto, 2008, Design Considerations of Porous Gas Enthalpy-Radiation Converters for Exhaust-Heat Recovery Systems, JSME, Vol.3, No.2, pp.319-329
Preecha Khantikomol, Shinichi Saito, Kouichi Kamiuto and Takehiko Yokomine, 2010, Study on Single Layer Flow Insulation Utilizing Ni-Cr Open-Cellular Porous Plate, International Communications in Heat and Mass Transfer, Vol.37 (8), pp.1015-1024
Preecha Khantikomol, Shinichi Saito and Yokomine, 2010, Study of Multilayer Flow Insulation utilizing Open-Cellular Porous Plates, J. Energy and Power Engineering, Vol.4 (11), pp.21-29
 

รายงานการประชุมทางวิชาการระดับนานาชาติ

Preecha Khantikomol and Kouichi Kamiuto, 2007, Design Considerations of Porous Gas Enthalpy-Radiaton Converters for Exhaust-Heat Recovery Systems, Proceedings of Thermal Engineering Conference 2007, No.07-45, September 23-2, 2007, Kyoto, Japan
Preecha Khantikomol, Shinichi Saito and Kamiuto, 2008, Combined Forced-Convection and Radiation Heat Transfer in an Open-Cellular Porous Plate, 45th National Heat Transfer Symposium of Japan, May 21-23, 2008, Tsukuba, Japan.
Kouichi Kamiuto and Preecha Khantikomol, 2008, Study of Multilayer Flow Insulator utilizing Open-cellular Porous Plates (Japanese Version) ,45th National Heat Transfer Symposium of Japan, May 21-23, 2008, Tsukuba, presented by Prof. Kamiuto.
Preecha Khantikomol, Shinichi Saito and Kouichi Kamiuto, Combined Forced-Convection and Radiation Heat Transfer in an Open-Cellular Porous Plate, The 7th JSME-KSME Thermal and Fluids Engineering Conference , 14-16 October 2008, Sapporo, Japan.
Preecha Khantikomol, Shinichi Saito and Yokomine, 2009, Study of Multilayer Flow Insulation utilizing Open-Cellular Porous Plates, International Conference on Power Engineering (ICOPE-09),16-20 November, 2009, Kobe, Japan.
Preecha Khantikomol, Shinichi Saito and Yokomine, 2010, Enhancement of Gas Enthalpy-radiation Conversion by Utilizing Open-Cellular Porous Materials, Proceedings of the 14th International Heat Transfer Conference (IHTC-14), 8-13 August 2010, Washington D.C. USA
P. Amatachaya, P. Khantikomol, R. Sangchot, and B. Kritacom, 2011, Steady State Transpiration Cooling System in Ni-Cr Open-Cellular Porous Plate, World Academy of Science, Engineering and Technology, Vol. 81, pp. 475-479
    Preecha Khantikomol and Wasan Srimuang1, 2011, A Numerical Analysis of Gas Enthalpy - Radiation Converter (GERC) by Using Single Cordierite Open-cellular Porous Plate, 2nd TSME International Conference on Mechanical Engineering, 19-21 October, 2011, Krabi, CD-ROM
    Wasan srimuang and Preecha Khantikomol, 2011, Investigation of effectiveness of a closed-end flat thermosyphon heat exchanger (CEFTHE), 2nd TSME International Conference on Mechanical Engineering, 19-21 October, 2011, Krabi, CD-ROM
    Preecha Khantikomol and Wasan Srimuangb, 2011, An EXPERIMENTAL INVESTIGATION OF HEAT TRANSFER CHARACTERISTICS OF A CLOSED-END OSCILLATING FLAT HEAT PIPE (CEOFHP), 10th International Heat Pipe Symposium (10th IHPS), Taipei, Taiwan, 2011, Nov. 6-9, 2011
    ธีระ ฮวบขุนทด, บัณฑิต กฤตาคมม และ ปรีชา ขันติโกมล, 2012, การศึกษาเชิงทดลองคุณสมบัติการเป็นฉนวนความร้อนไหลของวัสดุพรุนชนิดเซลลูลาร์เปิดคอร์ดิไรท์แผ่นคู่, การประชุมวิชาการเครือข่ายพลังงานแห่งประเทศไทยครั้งที่ 8 วันที่ 2-4 พฤษภาคม พ.ศ. 2555 จังหวัดมหาสารคาม
    อำพล ทันไชย, วสันต์ ศรีเมือง และ ปรีชา ขันติโกมล, 2012, การศึกษาเชิงทดลองคุณสมบัติการเป็นฉนวนความร้อนไหลของวัสดุพรุนชนิดเซลลูลาร์เปิดคอร์ดิไรท์แผ่นคู่, การประชุมวิชาการเครือข่ายพลังงานแห่งประเทศไทยครั้งที่ 8 วันที่ 2-4 พฤษภาคม พ.ศ. 2555 จังหวัดมหาสารคาม
     
     

    วารสารระดับประเทศ

    ปรีชา ขันติโกมล, 2553, การวิเคราะห์ความหนาของแผ่นวัสดุพรุนในระบบแปลงเอนทาลปีของก๊าซเป็นรังสีความร้อนหลายชั้นโดยใช้วัสดุพรุน ชนิดโฟมเซลล์เปิด, J. RMUTI, Vol.3 (2), pp.22-35
    Preecha Khantikomol, Maitree Polsongkram and Amorntud Juajamsai, 2010, Product Distribution from Woody Biomass by Fixed-bed Pyrolysis Process, RMUTI Journal, , Vol.4 (1), pp.1-9
    Wasan Srimuang and Preecha Khantikomol, 2012, Two Phase Closed Thermosyphon (TPCT) and Its Application for an Air-to-air Heat Exchanger, The Journal of KMUTNB, Vol.22, No.1, pp.191-208

    P. Khantikomol and B. Krittacom, 2012, A Comprehensive Review on Thermal Radiation of Open Cellular Porous Materials, Naresuan University Engineering Journal, Vol.6, No.2, pp.42-51

       
      Update 27 September 2012